Skip to main content

Quick Start: Connect Two Sites in 10 Minutes

Read this page for a first installation. From unboxing to a successful ping takes about 10 minutes.

Confirm before you start
  • One gateway at each site, already powered
  • The broadband account and password for each line at hand
  • No duplicate subnets between sites
Use only one access mode

Bridge, secondary router, or bypass router — follow the one you chose all the way through. Mixing them will never work.

Step 1 — Prepare the tools​

The gateway ships with a power supply; bring at least two Ethernet cables, a Windows 10/11 computer for setup, and the broadband account and password. Details: Preparation.

Step 2 — Register a platform account​

Open https://easytier.gshelp.xyz and click Register. Remember this account; you will enter it again in step 5. Details: Register and sign in to the networking platform.

Step 3 — Choose an access mode and wire it up​

Choose the mode first, then wire. Bridge and secondary router connect the gateway WAN port to the optical modem LAN port; bypass router connects the gateway LAN port to the switch. Details: Choosing an access mode.

Step 4 — Sign in to the gateway and configure the network​

Set the computer IP address to 192.168.10.x, then open https://192.168.10.1 in a browser. Account root, password admin. Details: Signing in to the gateway.

Step 5 — Enable the networking service​

In the admin page, open Services → EasyTier and select Enable. Set the start method to web configuration. Enter the server address udp://easytier.gshelp.xyz:22020/accountname. Details: Connecting the gateway to the platform.

Step 6 — Create a network and add the devices on the platform​

Sign in to the platform and click Network → Create Network. Add three initial nodes and set their protocols to UDP, TCP, and QUIC respectively. Details: Creating a network on the platform.

Step 7 — Configure subnet proxies and verify​

On the platform, configure a subnet proxy for each gateway, advertising only the local site subnet. Then ping the peer site's internal IP address from your computer. Details: Configuring subnet proxies.

What you should see when done
  • Member devices on the platform show Online
  • The peer site's internal IP address responds to ping

Stuck? Look here​

SymptomGo to
https://192.168.10.1 does not openCannot open the admin page, or no internet after configuration
No internet after configurationCannot open the admin page, or no internet after configuration
Device not visible on the platformDevice missing from the platform, or sites cannot reach each other

Next → Preparation: tools, environment, and address planning