Documentation
Getting Started
Installation and Access
Network Configuration
Verification and Maintenance
Preparation: Tools, Environment, and Address Planning
Read this checklist before you go on site. It takes about 15 minutes and saves half the rework.
Tools to bring
| Item | Notes |
|---|---|
| Gateway | Power adapter included |
| Ethernet cables | Two or more recommended |
| Setup computer | Windows 10/11 with an Ethernet port |
| Broadband account and password | Provided by the carrier; required for bridge mode |
| Optical modem admin access | Needed to switch the modem to bridge mode, or ask the carrier to do it |
First decide which situation the site is in
| Site situation | Recommended access mode |
|---|---|
| The modem can be set to bridge mode and the broadband account and password are available | Bridge mode (the gateway dials up) |
| The modem is in router mode and is hard to change | Secondary router mode, or bypass router mode |
| A router or switch already exists and the network structure must not change | Bypass router mode |
After deciding, read Choosing an access mode to confirm the cost.
Site information sheet
Fill this in before you go on site. It saves half the rework.
| Site name | Broadband account | Modem mode | LAN subnet | Gateway LAN IP | Notes |
|---|---|---|---|---|---|
| Example: Central Street store | ______ | Router / Bridge | 192.168.1.0/24 | 192.168.1.2 | ______ |
| Example: Jiefang Road store | ______ | Router / Bridge | 192.168.2.0/24 | 192.168.2.2 | ______ |
Subnet planning: no repeats between sites
Store A uses 192.168.1.x and store B also uses 192.168.1.x: the tunnel comes up, but the two sides cannot reach each other.
Give each site a different third octet: 192.168.1.x, 192.168.2.x, 192.168.3.x.
Do not take the shortcut of writing 0.0.0.0/0, and do not enter the peer site's subnet.
Common addresses and accounts
| Item | Value |
|---|---|
| Gateway admin address | https://192.168.10.1 |
| Gateway default account | root |
| Gateway default password | admin |
| Computer setup subnet | 192.168.10.x, mask 255.255.255.0 |
| Networking platform | https://easytier.gshelp.xyz |
| Server address template | udp://easytier.gshelp.xyz:22020/accountname |
Factory defaults may differ between batches. When the label and the table above disagree, the label wins.
Next → Choosing an access mode
Was this page helpful?A one-line note helps us make these steps more accurate.